Coolant RX • Model 3-N-1
Coolant System Service
- 100% 7-minute full coolant exchange; 85% 5-minute flush-n-fill
- Single large tube design with 5 gallon new fluid bucket performs like 2 and 3 tube designs
- Vacuum removal of old coolant and refill of new coolant
- Restores cooling system heat transfer efficiency.
- No air pockets-no spillage
- Sturdy, easy to roll around cart
- Visual comparison of new vs. used coolant increases sales
Coolant RX • Model 3-N-1
Benefits of COOLANT Rx
This preventative maintenance service flushes and cleans a vehicles cooling system and replenishes it with new engine coolant. According to new car warranty requirements and
service recommendations, engine anti-freeze should be
replaced every 24 months because anti-freeze performance degrades with time. Anti-freeze prevents coolant freeze up in
winter and boil over in summer. In addition, fluid replacement replenishes anti-freeze additives that protect an engine’s
cooling system from rust, corrosion, pitting, electrolysis and foaming.
How It Works
The Coolant Rx 3-n-1 machine replaces multiple tube machines with a single high capacity 8” tube and a 5-gallon new coolant container. A service hose, with a tapered rubber cone
attached, is inserted in place of the radiator cap. By using the “suction” side of the air pump to pull a vacuum in the machine’s selected storage tube, and at the same time “pulling” a vacuum in the engine’s cooling system, the coolant is removed. In most
cases, this is done without disconnecting any radiator hoses. To start the coolant exchange, the machine’s tube control valves are pointed to the tube that will be used to store the old coolant. The master control switch is then pointed to “vacuum”. As the liquid in the engine’s coolant system begins to warm-up, the vacuum generated by the pump will lower the boiling point of the liquid, thereby allowing it to be drawn into the tube. By observing the flow of liquid in the transparent service hose, the technician can determine when all of the available liquid has been drawn from the coolant system.
To install new coolant, the vacuum “pulled” on the engine’s
coolant system is used to draw the new coolant into the
radiator via the service hose connected to the new coolant reservoir. Turning the control valve to the new coolant accesses the new coolant container. New coolant is drawn into the coolant system and will stop flowing when the system is full.
The Coolant Rx machine typically pulls 20 inches of vacuum on a leak free coolant system. If the system has a leak, a less than normal vacuum reading will show on the vacuum pressure gauge mounted on the control panel.
Recommended Service Interval
Fuel Rx is recommended every 24 months. A RSS BusterTM chemical flush of the cooling system is recommended whenever coolant is exchanged.
Diagnostic Capabilities
Diagnostic capabilities include:
- Vacuum leak check
Technical Specifications
Compressed Air Source: 80-90 psi.
Hoses: 2 high capacity
Fluid Capacity: 5.0 gallons New Coolant
Tube Capacity: 7.6 gallons old Coolant
Standard Accessories: Included
Dimensions - 49" high, 18" wide x 14" deep
Weight - Single 8" diameter tube model approx. 100 lbs. (46 Kg.)
Tube Types: Epoxy
Cleaning Cycle: 10-40 minutes depending on service
Warranty: 5 year limited warranty on Epoxy tubes
Get In Touch